Unity XL Outdoor Kitchen Cart Assembly Guide

Quick Answer

Assemble your Keter Unity XL outdoor kitchen cart by following the included manual, but pay close attention to aligning the side panels and tightening screws evenly to avoid wobbles.

Assembly Steps

1. Prepare Your Workspace and Tools: Clear a flat, level area large enough to lay out all parts. You'll need a Phillips-head screwdriver (not included). Do not use power tools, as overtightening can strip the resin. Check that you have all parts from the box before starting.
2. Attach the Legs to the Base Panel: Insert the four legs into the corner sockets of the bottom panel. Ensure each leg clicks fully into place. Common mistake: forcing legs in at an angle can break the socket. If a leg doesn't slide in easily, check for debris in the socket.
3. Install the Side and Back Panels: Slide the left, right, and back panels into the grooves on the base and legs. They should fit snugly without screws at this stage. Common mistake: mixing up left and right panels – the cutouts for shelves must face inward. Dry-fit all panels before securing any screws.
4. Secure the Panels with Screws: Using the provided screws, attach each side panel to the legs and back panel. Tighten screws evenly in a cross pattern to avoid warping. Common mistake: overtightening one screw before the others can cause misalignment. Leave screws slightly loose until all are started, then tighten fully.
5. Install the Shelves and Door Hinges: Place the middle shelf onto the support tabs inside the cabinet. Attach the door hinges to the front frame, then hang the doors. Adjust the hinges for a flush fit. Common mistake: doors that rub or don't close evenly – loosen the hinge screws slightly and realign. Test door swing before tightening hinge screws completely.
6. Attach the Countertop and Handles: Place the stainless steel top onto the cart frame and secure it with the screws from underneath. Screw the cabinet handles onto the doors. Common mistake: the top may shift if not aligned with the frame before tightening. Have a helper hold the top steady while you fasten it.
7. Install the Wheels and Final Check: Snap the two locking casters into the front leg sockets and the two non-locking casters into the rear. Flip the cart upright. Check all screws are tight and doors open smoothly. Common mistake: using locking casters on all four corners makes the cart hard to maneuver. Lock the front wheels when the cart is in its final position.

Product Facts

• Signature Unity XL Outdoor Kitchen Cart with Storage - Walnut Brown: The Unity XL outdoor kitchen cart features weather-resistant resin with DecoCoat technology for a premium wood-look finish. This means the cart will withstand outdoor conditions without warping or fading, so you don't need to treat or seal it after assembly.