Dining Set Assembly: Porto Table with Metaline Chairs
By Keter - Outdoor Storage Solutions: Sheds, Deck Boxes, and More | Published: 2026-10-27
Category: How-to Guides
Learn how to assemble your Porto dining table and Metaline chairs step by step. Avoid common mistakes and get your outdoor dining set ready quickly.
Quick answer
Assemble the Porto dining table first, then the Metaline chairs. Use a soft surface, have a helper for the tabletop, and tighten all bolts gradually to avoid wobbles.
Before you start: tools and workspace
You need a Phillips-head screwdriver (or a power drill with a low torque setting), a rubber mallet (optional but helpful), and a clean, padded area like a blanket or cardboard to protect the tabletop finish. The Porto table has a wood-look coated steel frame that can scratch if dragged across concrete.
The Metaline chairs come with pre-drilled holes and matching hardware. Check that all parts are present before beginning. If any piece is missing, contact customer support rather than improvising with substitute hardware.
Common assembly pitfalls
The most frequent mistake is over-tightening bolts one at a time, which can misalign the frame and cause wobbles. Instead, hand-tighten all bolts first, then use a tool to cinch them evenly.
Another issue is confusing left and right chair legs. The Metaline chairs have asymmetric leg brackets; test-fit each leg before driving screws. Marking legs with tape as you go saves rework.
Step-by-step assembly instructions
- Unpack and inventory parts: Lay out all components on a clean, padded surface. Confirm you have the tabletop, four legs, crossbars, hardware bag, and four chair frames with seat/back pieces. Use the included manual to identify each part. Common mistake: discarding the manual or mixing chair leg sets. Keep the manual open and label legs with masking tape.
- Assemble the Porto table legs: Attach each leg to the tabletop bracket using the provided bolts. Hand-tighten only. Then install the crossbars between legs to form the base. Once all bolts are in place, tighten them evenly with a screwdriver. Checkpoint: after tightening, flip the table upright and press on the center. If it rocks, loosen all bolts slightly, re-align, and retighten.
- Assemble the Metaline chairs: For each chair, attach the left and right leg frames to the seat panel using the short bolts. Then attach the backrest panel. Tighten all bolts gradually, alternating sides. Repeat for all four chairs. Common mistake: forcing a bolt into a misaligned hole. If it doesn't slide in easily, loosen adjacent bolts and re-align the frame.
- Final positioning and leveling: Place the table in your desired outdoor location. Set each chair around it. Use a carpenter's level on the tabletop; if uneven, adjust the feet (if adjustable) or place thin shims under the legs. Do not drag the table or chairs across the patio. Checkpoint: after positioning, give each chair a gentle shake. Tighten any loose bolts before use.
Product facts
- Signature Porto Dining Table + Metaline Dining Chair, Set of 4 - Cappuccino: The Porto table combines a durable coated steel frame with Keter's Signature wood-look finish, delivering the timeless appeal of natural wood with the convenience of low-maintenance outdoor furniture. The wood-look finish means you don't need to stain or seal the table, but you should still handle it on a soft surface to avoid scratching the coating during assembly.
Signature Porto Dining Table + Metaline Dining Chair, Set of 4 - Cappuccino
