How to Assemble a Keter Hosting Party Table

By Keter - Outdoor Storage Solutions: Sheds, Deck Boxes, and More | Published: 2026-10-19

Category: How-to Guides

Follow this step-by-step guide to assemble your Keter Hosting Party Table quickly and correctly. Avoid common mistakes and get your outdoor party table ready.

Quick answer

Assembling your Keter Hosting Party Table takes about 30 minutes with two people. Follow these steps to avoid stripped screws and misaligned panels.

Why two people make it easier

The Hosting Party Table has a large top panel and a built-in cooler that add weight. One person can hold parts steady while the other tightens screws. This prevents cross-threading and keeps the frame square.

Tools you will need

You only need a Phillips-head screwdriver. A power drill with a low torque setting speeds things up but is not required. The included Allen key works for all bolts. Do not use a hammer or rubber mallet on the resin panels; they can crack.

Step-by-step assembly instructions

Step 1: Unpack and organize parts: Lay out all panels, screws, bolts, and the Allen key on a flat surface. Check the manual for the part list. Separate the table legs, side panels, cooler insert, and top panel. Missing a part? Contact Keter support before starting.
Step 2: Attach the side panels to the legs: Insert the bolts through the pre-drilled holes in the side panels and into the leg brackets. Tighten them loosely with the Allen key. Do not fully tighten yet; you need wiggle room for alignment. Common mistake: Over-tightening now can warp the panels.
Step 3: Connect the back panel: Slide the back panel into the grooves on the side panels. Secure it with the provided screws. Ensure the panel sits flush at the bottom. Use a screwdriver, not a drill, to avoid stripping the resin. If the panel does not slide easily, check for debris in the grooves.
Step 4: Attach the top panel and cooler: With a helper, lift the top panel onto the frame. Align the screw holes and insert the bolts. Tighten them fully. Then slide the cooler insert into the opening from underneath. Secure it with the clips provided. The cooler must sit level; adjust the clips if it wobbles.
Step 5: Tighten all bolts and level the table: Go back and fully tighten every bolt and screw. Place a level on the table top. If it is uneven, loosen the leg bolts slightly, adjust the legs, and retighten. Wipe down the surface with a damp cloth. A level table prevents drinks from spilling and keeps the cooler drain working.

Product features that matter for assembly

Hosting Party Tafel - 112x43x90 cm - Walnut: The table includes a built-in cooler that keeps drinks cold for hours. The cooler adds weight to the table top, so you need a second person to lift and align it during assembly.
Hosting Party Tafel - 112x43x90 cm - Walnut